(en) Optimal Control of Under-Actuated Legged Robots
- Contents -
1. Objective |
test | ||||||||
2. One-legged running robot |
1) ModelBased on energy analysis, we proposed a novel stabilization controller for a planar one-legged robot shown in Fig. 1. 2) Passive running gaitIt is impossible to obtain periodic running gaits analytically. Therefore we developed numerical search algorithm using Newton-Raphson method, based on the exact nonlinear hybrid dynamics. It involves calculation of fundamental matrix solution of variational equation at each phase (including discrete jump phase). All the calculations are carried out in terms of Poincare Map . Since the nontrivial passive running gaits are unstable period-one gaits (linealized Poincare Map has eigenvalues larger than unity), this robot cannot run without stabilizing controller. The instability increases as the forward speed does. 3) ControllerWe proposed two kinds of controllers: First, we derived a linear state feedback controller using only two control inputs that move the unstable poles to ZERO. This local feedback controller stabilizes running gaits, but its region of attraction is found to be very small, and large steady-state error remains. Secondly, we derived a new simple controller. Instead of depending on some pre-calculated periodic solutions, or target (desired) dynamics, here we tried to utilize the natural dynamics of the original nonlinear hybrid system to generate (unknown) natural running gaits. For this purpose, an energy-preserving control strategy has been proposed, in which the controller tries to minimize the dissipative energy as much as possible. The most important reason why we use this strategy is; if the system energy is preserved, the system is expected to generate natural periodic gaits, just as some class of Hamiltonian systems exhibit do. This strategy led to a new touchdown controller at flight phase. Based on the energy dissipation analysis, the controller deadbeat the state to ensure the energy preservation at touchdown. 4) Simulation
Simulation results shows that the robot can hop from wide set of initial conditions, and the generated running gaits are found to be quasi-periodic orbits, which can be seen in Hamiltonian system (Fig. 2). Since the controlled running gaits exist for every admissible energy level, they have some robustness against disturbances (Fig. 3).
It is shown that simple adaptation laws, which is similar to delayed feedback controllers for chaotic systems, can asymptotically stabilize quasi-periodic gaits to the periodic ones having desired period for some cases (Fig. 4). In particular, for 1-periodic gait, the robot eventually hops without any control inputs (Fig. 5). Animation
|
||||||||
3. Biped running robot |
1) ModelWe consider a highly-nonlinear planar biped model having massive legs and torso (Fig. 7)
2) ControllerUnfortunately, complete passive running gaits cannot be found by numerical search algorithm. Nevertheless, we can stabilize this system. The controller of passive one-legged hopper is extended to the biped robots. Specifically, we derive dead-beat controller at flight phase based on the energy-preserving strategy to preserve mechanical energy at touchdown. Then, we combine this with a posture controller at stance-phase to obtain stable running gaits. 3) SimulationAnimation
The planar controller is partially extended to a 3D biped model, where a rotor rotating around yaw-axis of torso was introduced. The next task is to realize complete passive running gaits. To do so, we should introduce hip springs to make legs swung passively both at flight phase and stance phase. This implies replacing stance phase controller with another one, where the control input eventually converges to zero. |
||||||||
4. Quadruped running robot |
1) ModelThe model of our robot is shown in Fig. 10. The legs are connected to the body through revolute joints. Each leg includes upper and lower sections, which are connected with a linear spring. The distance between the toe and hip changes because of the sliding motion between the lower and the upper section of the legs, so each leg has one linear passive degree of freedom. The first research is to explore the properties of passive running, no control input assembles are configured in our profile. In replace, we set two springs in hips. This setting is expected to save the leg swinging energy. To summarize, each leg in our robot has two degree of freedom: a rotational one and a linear one and both of them are completely passive. 2) Passive running gaitIn a complete bounding cycle, a full stride of the robot can be divided in four different phases. These phases are:
Each of the above phases is triggered by an appropriate event: "Touchdown" or "Liftoff". These events occur for each of the front and back legs, so four events can be defined: "Back Leg Touchdown", "Front Leg Touchdown", "Back Leg Liftoff" and "Front Leg Liftoff". A complete bounding cycle is showed in Fig. 11. We can see from the figure that each of these events initiates the corresponding phase. As we do not assume a specific running sequence for this algorithm, the propagation of the system follows no specific order. Only the gaits which tend to converge will exhibit a repetition of ordered phases. 3) SimulationThe following figures show different gaits of different profiles.
Animation
Different from other related studies, all the passive running gaits we found are proved to be unstable. Although the motion starting from the fixed points can continue for some steps (25 steps as maximum), it falls finally. Extensive investigation of characteristic multipliers corresponding to the trajectories revealed that they all have eigenvalues whose magnitude is bigger than unity. Another property we found from the passive running gaits is the symmetricity involved in the running pattern. Our simulations reveal that all the gaits of both Gait 1 and Gait 2 exhibit symmetrical behavior. Our ongoing task is to develop orbital stabilization controllers. |
||||||||
4. Publication |
|
2024/06/23